A-1-2 Saving The Node Address Setting - Omron FH Series Operation Manual

A-1-2 Saving the Node Address Setting
When the node address switch setting is "00" (Software Setup mode), the node address value you set
in Sysmac Studio is enabled. If the node address switches are set to any other value, the value that is
set on the switches is used as the node address.
In the Software Setup mode, in Sysmac Studio, execute [Write Slave Node Address] on the [EtherCAT
Edit] screen to save the slave node address setting in the nonvolatile memory of the FH series Vision
Sensor.
Software Setting
The set value saved as Slave Information Interface (SII) information in the nonvolatile memory of the
slave is the node address.
EtherCAT master
(4) (5)
Node Address Switch Setting
The value set on the node address switches is the node address.
EtherCAT master
(3) (4)
Vision System FH Series Operation Manual for Sysmac Studio (Z343)
Nonvolatile
EtherCAT
(2)
memory
Slave Controller
Register : 0010h
(3)
Register : 0012h
Node Address
(1)
Switch
EtherCAT Slave
Nonvolatile
EtherCAT
memory
Slave Controller
Register : 0010h
(2)
Register : 0012h
Node Address
(1)
Switch
EtherCAT Slave
(1) The Node Address Switch is set to "00" at
power OFF.
(2) Write a node address set value to Slave SII
SII
from the master.
(3) The value of the node address setting is applied
to Register: 0012 hex by the software, when the
slave power is ON.
(4) EtherCAT master reads the set value of
Register: 0012 hex.
(5) EtherCAT master writes the value of 0012 hex
address to 0010 hex address as the node
address value.
(1) The Node Address Switch is set at power OFF.
(2) The value of Node Address Switch is applied to
Register: 0012 hex, when the slave power is
SII
ON.
(3) EtherCAT master reads the set value of
Register: 0012 hex.
(4) EtherCAT master writes the value of 0012 hex
address to 0010 hex address as the node
address value.
Appendices
A
A - 3