Pivot Bearing Replacement - Honda V65 MAGNA Shop Manual

~
V65MAGNA
PIVOT BEARING REPLACEMENT
Remove the dust seals and bearings from both
sides of the swingarm as follows:
Remove the swingarm bearings using the bearing
remover head, 07936-8890200, shaft, 07936-
8890100 and weight 07936-3710200. Install the
remover and expand it as much as possible behind
the bearing race. Strike the weight lightly several
times to move the race out enough so that the
remover can be expanded completely. Expand the
remover completely. Slide the weight again with
enough force to remove the race.
INSTALLATION
NOTE:
Replace the inner and outer bearing races as
a set. Replace the grease retainer plate when-
ever it is removed.
Install new grease retainer plates. Drive new outer
bearing races into the swingarm.
BEARING REMOVER
HEAD
07936-8890200
DRIVER
07749-0010000
REAR WHEEL/SUSPENSION
SLIDING HAMMER WEIGHT
07936-3710200
~
BEARING REMOVER
SHAFT
07936-8890100
ATTACHMENT,
37 x 40 mm 07746-0010200
Apply grease to the pivot bearings dust seals and
pivot bolt tips.
Install the bearings and dust seals.
Date of Issue: Dec, 1982
© HONDA MOTOR CO., LTD.
RIGHT PIVOT BOLT
281
BEARINGS
DUST SEALS
16-15