Platen Cover Sensor, Ardf Position Sensor - Ricoh MP 305 Plus Field Service Manual

3. Adjust the vertical scanning with SP4-803-001 (HP Position Adjust).
4. Turn OFF then ON the main power to apply the SP setting.
5. Adjust the carriage parallel if necessary
• The CIS correction value is stored in an EEPROM on the BiCU. This correction value must be
re-adjusted after the CIS unit is replaced.
• SP4-008 (Sub scan magnification Adj)
• SP4-010 (Sub scan registration Adj)
• SP4-011 (Main scan Reg)
• SP4-688-001 (DF density adjustment ARDF)

Platen Cover Sensor, ARDF Position Sensor

1. Rear cover (page 147)
2. Remove the following:
1. Platen cover sensor [A]
2. ARDF position sensor [B]
(page 199).
Scanner
197