Sc682-01, -06, -11, -16, -21, -26, -31, -36 - Ricoh MP 305 Plus Field Service Manual

An error occurred during EEPROM communication, but recovery failed after retrying three
times.
This SC is detected when:
• there is an overrun error (ORE=1).
• there are other errors defined by the software designer.
• SC681-31
Unknown
• SC681-36
An error occurred during EEPROM communication, but recovery failed after two retries.
Possible Causes
• There is noise.
• The connection is loose.
• There is mis-operation (SC681-01, -06, -21, -26, -31).
Troubleshooting Procedures
• Turn the main power OFF. See if the SC recurs.
• Replace the BiCU.

SC682-01, -06, -11, -16, -21, -26, -31, -36

Error Name
SC682-01: TD Sensor Communication Error: Invalid Device ID
SC682-06: TD Sensor Communication Error: Channel Error
SC682-11: TD Sensor Communication Error: Device Error
SC682-16: TD Sensor Communication Error: Communication Abort Error
SC682-21: TD Sensor Communication Error: Communication Timeout Error
SC682-26: TD Sensor Communication Error: Operation Stopped Error
SC682-31: TD Sensor Communication Error: Buffer Full Error
SC682-36: TD Sensor Communication Error: Verification Error
Type
D
Symptoms
• SC682-01
An error occurred during EEPROM communication, but recovery failed after retrying three
times.
SC6xx (Including Controller Service Calls)
437