Connecting Got With The Inverter; Function Overview; System Configuration - Mitsubishi FREQROL-E700 Manual

5.1 Connecting GOT with the inverter

This document describes the procedure to establish a peer-to-peer connection with Mitsubishi general-purpose
inverter FR-E700 series and Mitsubishi GOT2000 series GT2708.
Refer to specific manuals for information on connecting other inverters and GOTs.

5.1.1 Function overview

GOT is an acronym for Graphic Operation Terminal.
Hardware switches and lamps installed to a conventional control panel have been replicated in software and
combined with a touch panel display device to enable viewing of information and device operation via the
monitor screen. The GOT can connect and send commands to up to 31 inverters via RS-485 communication.
The GOT is equipped with USB ports located in the front so that doors do not have to be opened when
performing inverter maintenance. The USB port on the GOT can be used to connect inverters without USB ports
to PCs and use FR Configurator. Parameter configuration backups to SD cards can be performed with GOT2000
or later devices, which enables you to replace your Mitsubishi general-purpose inverter of the same type and
restore the configuration saved on the SD card to the new inverter. This backup and restore functionality also
significantly reduces time to load data into devices and equipment used for mass production.

5.1.2 System configuration

When connecting to one inverter
Inverter
Inverter
Control terminal
Model name
option
FREQROL-E700
Control
terminal
option
Communication
type
- RS-485
Connection cable
Connection cable
Connection Max.
diagram number distance
RS485
connection 500m
diagram
5-2
GOT
GOT
Option device Model
- (Built into GOT)
GT15-RS4-9S
GT10-C02H-9SC
Number of
connectable
equipment
1 GOT for
1 inverter