Fusing Lamps - Ricoh B010 Service Manual

Rev. 3/2002

3.8.8 FUSING LAMPS

⇒
Cleaning roller assembly ( 3.8.7)
Left end of fusing lamp
[A]: Fusing lamp harness ( x 2)
[B]: Fusing lamp cover ( x 2)
[C]: Left fusing lamp bracket ( x 1)
Rotate the rubber cushions until
the cutout faces down, then
remove the harnesses from the
bracket.
Right end of fusing lamp
[A]: Open clamps x 4
[B]: Fusing lamp cover ( x 1)
[C]: Fusing lamp bracket ( x 1)
[D]: Turn the rubber cushion until the
cutout faces down, then remove
the harnesses from the bracket.
[E]: Fusing lamps
NOTE: After the lamps are re-
installed, make sure that the
rubber cushions are rotated
so the slits are facing up to
prevent the lamps from slipping out.
SM
[A]
[B]
[C]
[D]
[E]
B010R511.WMF
3-31
FUSING SECTION
[B]
[C]
B010R510.WMF
[A]
B010