Installation Procedure - Ricoh B010 Service Manual

ROLL TRAY INSTALLATION PROCEDURE

1.3.2 INSTALLATION PROCEDURE

[A]
[E]
[J]

CAUTION
1. Unplug the main machine power cord before starting the following procedure.
2. Before starting the installation, insert the leveling shoes under the leveling feet, and
level the machine.
3. The machine is very heavy. To avoid serious injury, make sure that you have a
sufficient number of people to assist, and use proper lifting equipment for lifting or
moving.
4. The feed tray is weighs 36 kg (80lbs) and requires at least two people to lift and install.
NOTE: Keep the shipping retainers after installing the machine. They will be
reused if the machine is moved to another location in the future.
1. Turn off the copier main switch.
2. Remove the following covers:
1) Right front [A] and rear [B] covers (4 screws, 6 screws).
2) Left front [C] and rear [D] covers (4 screws, 6 screws).
3) Rear covers [E] (9 screws).
3. Remove the lower cover [F] and two brackets [G] (2 screws each).
4. Remove the power supply unit [H] (4 screws, 16 connectors).
NOTE: Before removing the Line and Neutral bayonet connectors [I] from the
PSU, mark them "L" and "N" to prevent reversing their positions when they are
re-attached. "L" (Line) is on the right, and "N" (Neutral) is on the left.
5. Remove the toner collection bottle [J]
B010
[C] [D]
[B]
B010I501.WMF
[H]
[G]
[E]
[F]
B010I502.WMF
[I]
B010I503.WMF
1-12
[G]
SM