Table of Contents
Advertisement
3.
Unplug the ballast/power supply cable from X1 and the lamp control cable from the connector on
the ballast. Squeeze the latch on the side of the power supply/ballast cable connector to release
it. (The illustrations below show the ballast already removed so you can see it more clearly.)
4.
Remove the two M3x8 screws that fasten the ballast to the chassis.
5.
Lift the ballast away from the chassis.
TDP-MT8 Service Guide
8
- Quick Links:
- Power and Start-Up Problems
Hide quick links:
Advertisement
Table of Contents
