Toshiba TDP-MT8 Service Manual page 61

Assembly Notes
♦
The keypad ECA, the key set and the keypad reflector fit only one way in the top case. Make sure
that the alignment holes in the keypad ECA fit over the pins in the top case.
♦
If the keypad reflector is new, remove the protective paper from the adhesive before installing it.
Position the reflector in the recess on the inside of the top case. Press the reflector firmly against the
top case.
♦
Make sure that the collar on each key fits flush against its hole in the top case.
♦
Torque the eight black M3x6 Plastite Torx screws to 4 in.-lbs. (.452 Nm).
TDP-MT8 Service Guide 61