Assembly Notes
♦
Insert the power supply into the chassis with the forward side up to allow the AC line connector to
pass through the hole in the chassis.
♦
Torque the six M3x8 Torx screws to 6 in-lbs (.68 Nm).
♦
Connect the ground terminal to the chassis. Torque the M3x8 Torx screw to 6 in-lbs (.68 Nm).
♦
Connect the safety switch cable to J3 on the power supply. Then connect the power supply/controller
ECA cable to P1, the ballast/power supply cable to J1 and the lamp control cable to J4 on the power
supply.
♦
Make sure that you route the safety switch cable through the eye at the front left side of the chassis.
TDP-MT8 Service Guide
46