Remove And Replace The Elevator - Toshiba TDP-MT8 Service Manual

Remove and Replace the Elevator

The elevator is comprised of the elevator spring, elevator actuator and elevator shaft. The elevator
shaft includes a molded foot. The elevator button in the top case moves the elevator actuator to allow
the shaft to extend or retract and adjust the level of the projected image. The elevator housing is molded
into the bottom case. Except for the housing, each part can be replaced separately.
Remove the Elevator Shaft
1. Remove the following items:
Outer handle (see page 41)
Rear bezel (see page 51)
Top case (see page 57)
2. Use a small screwdriver to move the elevator actuator toward the right side of the projector. This
disengages the actuator and allows the elevator shaft to travel freely up and down. Keep the
actuator in this position as you complete the next step.
TDP-MT8 Service Guide 19