5.
When you release all 3 retainer tabs, grasp the zoom ring and pull it off of the lens barrel.
Assembly Notes
♦
Align the three tabs on the zoom ring with the three holes on the lens barrel. Push the ring onto the
lens barrel. The lens barrel should fit snugly against the collar inside the zoom ring. Rotate the zoom
ring to ensure that the tabs properly engage the holes.
♦
Align the three slots on the focus ring with the three alignment pins on the end of the lens barrel.
Press the focus ring into place. Rotate the focus ring to ensure that the slots properly engage the
alignment pins.
♦
Place the lens cap over the focus ring.
TDP-MT8 Service Guide
30