Toshiba TDP-MT8 Service Manual page 52

4. Remove the security plate and save it for use with the replacement rear bezel. Use a small flat
blade screwdriver to gently pry the security plate away from the rear bezel.
Assembly Notes
When you install a new rear bezel:
♦
Affix the new I/O panel label to the outside of the bezel.
♦
Align the two tabs on the rear IR lens with the slots on the rear bezel. Press the lens into place
against the outside of the rear bezel.
♦
Affix the security plate to the inside of the bezel. If the plate is new, remove the protective paper from
the adhesive before installing it. Position the security plate in the recess on the inside of the rear
bezel. Press the plate firmly against the rear bezel.
♦
Torque the two M3x8 Torx screws to 6 in/lbs (.68 Nm)
TDP-MT8 Service Guide 52