Toshiba TDP-MT8 Service Manual page 67

Image #4: SMPTE133
Project the SMPTE133 image.
On the keypad, press Menu.
On the Display menu, select
Factory Reset.
IR in port test
12V trigger port test
Power Down
After all tests are complete,
turn the power off and
disconnect all cables. Attach
the lens cap.
TDP-MT8 Service Guide
Verify that the bars are not flashing.
Verify that the transitions from light to dark are smooth and gradual.
Verify that there are no noise, tint, duplicating columns, or other general
image abnormalities present
Verify that the image synchronizes.
Connect a cable between the remote control and the IR in port on the
projector. Verify that the projector responds to remote commands through
the port.
Trigger 2 should read 12VDC whenever the projector is powered on and
in 16:9 display mode.
Verify unit is powered off before disconnecting cables.
67