Installing The Network Board - Canon Laser Shot LBP5200 Getting Started Manual

b
LAN Connector
Connects to a 10BASE-T/100BASE-TX LAN cable.
c
Status Lamp
Shows the status of the network board. If the lamp flashes when the LAN
cable is not connected, the network board is malfunctioning.
d
Power Lamp
This light turns on when the printer is on. If this lamp does not come on
when the printer is turned on, the network board is malfunctioning.
e
MAC Address Label
Displays the MAC address of this network board.

Installing the Network Board

Install the network board in the expansion board slot located on the rear of
the printer using the following procedure. You will need a Philips-head
screwdriver to install the network board. Prepare a screwdriver in advance
that matches the size of the screws.
CAUTION
•
Make sure that the printer is turned off and that all interface cables
and power cord are disconnected from the printer before installing
the network board. Attempting to install the board with the power on
may result in electrical shock.
•
Take care when you are handling the network board. Do not touch the
corners or sharp areas of the network board as this may cause
personal injury.
IMPORTANT
The network board contains components that are sensitive to static
electricity. To avoid damaging the board due to static electricity, observe
the following handling precautions.
- Touch a metal object to dissipate static electricity before handling the
network board.
- When handling the network board, do not touch anything that generates
static electricity such as the computer display.
- Do not touch any of the components, printed wiring, or connectors on the
network board.
- To avoid the effects of static electricity, do not remove the network board
from the protective bag until immediately before you install it. The
protective bag is also needed when you remove the network board.
Store the protective bag and do not discard of it.
1
Press the power switch to turn the printer off a, remove the
USB cable b, and disconnect the power plug from the
power outlet c.
c
a
2
Remove all the interface cables and the power cord from
the printer.
If there is not enough space to install the network board, move the printer to a
place where it is easier to work.
b
Step
6
43