Setting The Clock Manager - Cisco Nexus 9000 Series Configuration Manual

Basic Device Management
Step 2

Setting the Clock Manager

You can configure the clock manager to synchronize all the clocks of the components in the Cisco Nexus
device.
Procedure
Step 1
Step 2
Command or Action
Example:
switch# clock set 15:00:00 30
May 2013
Fri May 30 15:14:00 PDT 2013
show clock
Example:
switch(config)# show clock
Command or Action
clock protocol protocol
Example:
switch# clock protocol ntp
show run clock_manager
Example:
switch# show run
clock_manager
Cisco Nexus 9000 Series NX-OS Fundamentals Configuration Guide, Release 7.x
Purpose
The format for the time argument is hh:mm:ss.
The range for the day argument is from 1 to 31.
The values for the month argument are January, February,
March, April, May, June, July, August, September,
October, November, and December.
The range for the year argument is from 2000 to 2030.
(Optional)
Displays the current clock value.
Purpose
Configures the clock manager.
The values for the protocol argument are ntp and none.
The following describes the values:
• ntp—Synchronizes clocks with Network Time Protocol
(NTP).
• none—Uses clock set HH:MM:SS to set the supervisor
clock.
When none is used, the clock must be
Note
configured.
Once the protocol is configured, the clock must
Note
use that protocol.
(Optional)
Displays the configuration of the clock manager.
Setting the Clock Manager
93