Cisco Nexus 9000 Series Configuration Manual page 33

Using the Cisco NX-OS Setup Utility
Example:
Configure read-only SNMP community string (yes/no) [n]: yes
SNMP community string : snmp_community_string
For information on SNMP, see the Cisco Nexus 9000 Series NX-OS System Management Configuration Guide.
Step 7 Enter a name for the device (the default name is switch).
Example:
Enter the switch name: switch_name
Step 8 Configure out-of-band management by entering yes. You can then enter the mgmt0 IPv4 address and subnet
mask.
Note
Example:
Continue with Out-of-band (mgmt0) management configuration? [yes/no]: yes
Mgmt0 IPv4 address: mgmt0_ip_address
Mgmt0 IPv4 netmask: mgmt0_subnet_mask
Step 9 Configure the IPv4 default gateway (recommended) by entering yes. You can then enter its IP address.
Example:
Configure the default-gateway: (yes/no) [y]: yes
IPv4 address of the default-gateway: default_gateway
Step 10 Configure advanced IP options such as the static routes, default network, DNS, and domain name by entering
yes.
Example:
Configure Advanced IP options (yes/no)? [n]: yes
Step 11 Configure a static route (recommended) by entering yes. You can then enter its destination prefix, destination
prefix mask, and next hop IP address.
Example:
Configure static route: (yes/no) [y]: yes
Destination prefix: dest_prefix
Destination prefix mask: dest_mask
Next hop ip address: next_hop_address
Step 12 Configure the default network (recommended) by entering yes. You can then enter its IPv4 address.
Note
Example:
Configure the default network: (yes/no) [y]: yes
You can only configure IPv4 address in the setup utility. For information on configuring IPv6, see
the Cisco Nexus 9000 Series NX-OS Unicast Routing Configuration Guide.
The default network IPv4 address is the same as the destination prefix in the static route configuration.
Cisco Nexus 9000 Series NX-OS Fundamentals Configuration Guide, Release 7.x
Setting Up Your Cisco NX-OS Device
19