Cisco Nexus 9000 Series Configuration Manual page 34

Setting Up Your Cisco NX-OS Device
Default network IP address [dest_prefix]: dest_prefix
Step 13 Configure the DNS IPv4 address by entering yes. You can then enter the address.
Example:
Configure the DNS IP address? (yes/no) [y]: yes
DNS IP address: ipv4_address
Step 14 Configure the default domain name by entering yes. You can then enter the name.
Example:
Configure the DNS IP address? (yes/no) [y]: yes
DNS IP address: ipv4_address
Step 15 Enable the Telnet service by entering yes.
Example:
Enable the telnet service? (yes/no) [y]: yes
Step 16 Enable the SSH service by entering yes. You can then enter the key type and number of key bits. For more
information, see the Cisco Nexus 9000 Series NX-OS Security Configuration Guide.
Example:
Enable the ssh service? (yes/no) [y]: yes
Type of ssh key you would like to generate (dsa/rsa) : key_type
Number of
Step 17 Configure the NTP server by entering yes. You can then enter its IP address. For more information, see the
Cisco Nexus 9000 Series NX-OS System Management Configuration Guide.
Example:
Configure NTP server? (yes/no) [n]: yes
NTP server IP address: ntp_server_IP_address
Step 18 Specify a default interface layer (L2 or L3).
Example:
Configure default interface layer (L3/L2) [L3]: interface_layer
Step 19 Enter the default switchport interface state (shutdown or no shutdown). A shutdown interface is in an
administratively down state. For more information, see the Cisco Nexus 9000 Series NX-OS Interfaces
Configuration Guide.
Example:
Configure default switchport interface state (shut/noshut) [shut]: default_state
Step 20 Enter the best practices profile for control plane policing (CoPP). For more information, see the Cisco Nexus
9000 Series NX-OS Security Configuration Guide.
Cisco Nexus 9000 Series NX-OS Fundamentals Configuration Guide, Release 7.x
20
key bits <768-2048> : number_of_bits
Using the Cisco NX-OS Setup Utility