Settings For The Loaded Media - Epson SureColor SC-S70600 series Operator's Manual

EPSON SC-S70600 series/SC-S50600 series
R
While holding the tabs of the media holding
plates on both sides, move the plate to the edge of
the media.
Adjust so that the edge of the media is aligned to
the center of the round holes in the media
holding plates.
c
Important:
❏ Do not use the media holding plates with
media that is 0.4 mm or thicker. The
media holding plates could touch and
damage the print head.
❏ Always position the plates so that the
edges of the media are at the centers of the
round holes. Incorrect positioning causes
banding (horizontal banding, tint
unevenness, or stripes) during printing.
❏ Move the media holding plates to the left
and right edges of the platen when they
are not in use.
❏ Do not use the media holding plates if the
sides of the printed media are smudged or
torn.
Operator's Guide
Basic Operations
S
Settings for the Loaded
Media
The control panel displays the following information
once the media is loaded.
This display can be used to view or change the following
two options:
❏ Remaining Setup
On: The printer displays the amount of media
remaining.
Off: The printer does not display the amount of
media remaining.
When Remaining Setup is On, the printer will
calculate the approximate amount of media
remaining based on the length of the roll and the
amount used for printing and display this
information in the control panel. The display gives
a rough idea of the amount of media available
before printing, making it easier to know when
media requires replacement.
In addition, a warning will be displayed when the
amount of media remaining reaches a specified
level.
13