Table of Contents
Advertisement
SC-F6400 Series/SC-F6400H Series
Loading Media
As shown below, you can load media while checking
the procedure on the panel screen.
You can also watch the video on YouTube.
Epson Video Manuals
A
Check that Load the media. is displayed on the
screen, and then press
B
Press Start - See Description on the screen to
view the procedure.
Follow the on-screen instructions to perform
the procedure.
User's Guide
Basic Operations
.
36
Make settings for Loaded
Media
Make settings for the loaded media.
A
Press Media to select the registered media
number that contains the settings
corresponding to the loaded media.
When Media Settings have not been
registered for the loaded media
In this situation, select an unregistered number.
In an unregistered status, the Media Type is set
to Med-Thick 70g/m
the loaded media is 61 to 89 g/m
leave this as it is.
Change the media type if the paper weight
differs from that of the loaded media. Failure to
select the appropriate Media Type could cause
problems with print quality.
To change the media type, press
Media Type on the screen where the registered
media number is displayed.
Select the Media Type using the paper weight of
the loaded media as a guideline as shown
below. The paper weights of each Media Type
shown on the screen are typical values.
After making your selection, press the Close
button.
2
. If the paper weight of
2
, you can
- Edit -
Advertisement
Table of Contents
