Manual Focus - Canon EOS C200 Instruction Manual

Required settings on EF Cinema lenses
To adjust the focus from the camera, you will need to change the focus mode using the controls on the lens.
Required settings vary depending on the lens. Refer to the following table and the instruction manual of the lens
used.
Lens
EF lens
CN7x17 KAS S/E1
CN20x50 IAS H/E1
CN-E18-80mm T4.4 L IS KAS S

Manual Focus

Focus manually using the focus ring on the lens.You can also perform this function remotely using Browser
Remote on a connected network device (A 158).
The autofocus mode is set to [One Shot] by default. If you need to change the setting, start the procedure from
the beginning. Otherwise, you can start from step 3 below.
1 Open the focus [AF Mode] submenu.
> [v $ Camera Setup] > [AF Mode]
2 Select [One Shot] and then press the joystick.
• On an EF lens, you can set the lens's focus mode switch to MF. On a compatible EF Cinema lens, enable
manual adjustment on the lens (A 80).
3 Press the FOCUS GUIDE button to display the focus guide.
• If you are not using the camera grip, you can alternatively set an
assignable button to [Focus Guide] (A 119).
1
4 On the LCD screen , touch the subject to focus on.
• Alternatively, you can push the joystick up/down/left/right.
• You will not be able to touch the subject if the focus guide is not
displayed.
• For details on using the focus guide, refer to
Guide
(A 82).
1
Supplied accessory for the C200; optional accessory for the C200B.
5 Turn the focus ring to adjust the focus.
NOTES NOTES
• With some EF lenses, you may be able to operate the focus ring even when the focus mode switch is set to
AF.
• If you operate the zoom after focusing, the focus on the subject may be lost.
• If you focus manually and then leave the camera with the power turned on, the focus on the subject may be
lost after a while. This possible slight shift in focus is a result of the internal temperature rising in the camera
and lens. Check the focus before resuming shooting.
• When adjusting the focus, be careful not to touch the front of the lens or moving parts on the lens except for
the focus ring.
• When an optional RC-V100 Remote Controller is connected to the camera, you can adjust the focus with the
remote controller's FOCUS dial. At default settings, turn the dial right to focus farther and left to focus nearer.
Part used on the lens
Focus mode switch
Focus operation change-over knob
Autofocus/Manual Focus
change-over switch
Dual Pixel Focus
Setting for automatic adjustment
AF
SERVO
AF
Adjusting the Focus
Setting for manual adjustment
MF
MANU.
MF
81