Frame Recording Mode - Canon EOS C200 Instruction Manual

Frame Recording Mode

We recommend operating the camera remotely or stabilizing the camera, for example, on a tripod. Sound is not
recorded in this mode.
Activating and Configuring
1 Open the [Recording Mode] submenu.
> [Æ ! Recording/Media Setup] > [Recording Mode]
2 Select [Frame Recording] and then press the joystick.
• [FRM STBY] appears at the top of the screen (with [FRM] flashing).
Recording
1 Press the REC button to begin recording.
• The camera automatically records one frame.
• The tally lamp illuminates.
• [FRM STBY] changes to [Ü FRM REC] while recording frames and [Ü FRM STBY] when frames are not
being recorded.
• Repeat until you finish recording.
2 When you have finished recording, turn off the special recording mode.
• Repeat steps 1 and 2 of the previous procedure selecting [Normal Recording] instead.
• Frame recording mode ends and all of the recorded frames are joined together into one clip.
• The tally lamp goes out and [STBY] appears at the top of the screen.
NOTES NOTES
• You can use only one special recording mode at a time.
• Some frames at the point the recording was stopped may be recorded and added to the end of the clip.
• If the system frequency, frame rate or resolution/color sampling is changed, frame recording mode will be
canceled.
• About the time code during frame recording mode:
- The time code mode can be set to [Regen.], or to [Preset] with [Rec Run] running mode.
- If the time code running mode was set to [Free Run], the time code running mode will be changed
automatically to [Rec Run] when interval recording is activated.
- When the special recording mode is deactivated, the time code running mode will return to its previous
setting.
- The time code signal will not be output from the SDI terminal or HDMI OUT terminal.
Special Recording Modes
113