Table of Contents
Advertisement
Taking Photos
Photos are saved onto SD card B and their size depends on the video configuration currently in use.
Resolution currently in use
4096x2160
3840x2160
1920x1080
Operating modes:
1 Set an assignable button to [Photo] (A 119).
2 When the camera is in record standby mode, press the assignable button to take a photo.
• 7 and the number of available photos appear on the upper right of the screen.
• The SD CARD 3 access indicator will illuminate in red as the photo is being recorded.
IMPORTANT
• Observe the following precautions while the SD CARD 3 access indicator is illuminated in red. Failure to do
so may result in permanent data loss.
- Do not disconnect the power source or turn off the camera.
- Do not remove the SD card.
NOTES
NOTES
• Photos cannot be taken during pre-recording mode.
• You cannot take photos while using Browser Remote.
• If the LOCK switch on the SD card is set to prevent writing, you will not be able to record photos or grab
frames. Change the position of the LOCK switch in advance.
Photo size
Approximate file size per image
2048x1080
3840x2160
1920x1080
Taking Photos
930 KB
3,080 KB
880 KB
115
Advertisement
Table of Contents
