Scissor Assembly, Gs-3246 - Genie GS-2046 Service Manual

June 2003
800-610-4101
ActionRental.com
REV A
3-3

Scissor Assembly, GS-3246

How to Disassemble the
Scissor Assembly, GS-3246
Bodily injury hazard. This
procedure requires specific repair
skills, lifting equipment and a
suitable workshop. Attempting this
procedure without these skills and
tools could result in death or
serious injury and significant
component damage. Dealer
service is required.
When removing a hose assembly
or fitting, the O-ring on the fitting
and/or hose end must be replaced
and then torqued to specification
during installation. Refer to
Section Two, Hydraulic Hose and
Fitting Torque Specifications.
1 Remove the platform. See 2-1, How to Remove
the Platform.
2 Remove the cables from the side of the number
5 outer arm (index #18) at the ground controls
side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
Part No. 72972
3 Attach a lifting strap from an overhead crane to
4 Remove the external snap rings from the
5 Use a soft metal drift to remove the number 5
6 Remove the external snap rings from the
7 Use a soft metal drift to remove the number 5
8 Remove the cable clamps from the number 5
9 Remove the mounting fasteners from the upper
10 Remove the mounting fasteners from the upper
11 Remove the upper cable tray from the scissor
Genie GS-2046 and GS-2646 and GS-3246
Section 4 • Repair Procedures
SCISSOR COMPONENTS
the number 5 outer arm (index #18).
number 5 center pivot pin (index #2).
center pivot pin (index #2).
number 5 pivot pin (index #19).
pivot pin (index #19) from the non-steer end of
the machine. Remove the number 5 outer arm
(index #18) from the machine.
Crushing hazard. The number 5
outer arm (index #18) may
become unbalanced and fall if not
properly supported when it is
removed from the machine.
inner arm (index #17). Lay the cables off to the
side of the machine.
cable tray supports.
cable tray mounting bracket on the number 4
center pivot pin (index #5) at the ground
controls side of the machine.
assembly.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
4 - 33