Roland VersaUV LEF-20 Master Manual page 69

Message
SERVICE CALL ****
TEMPERATURE IS TOO LOW
**°C
DATA ERROR CANCELING . . .
WRONG CARTRIDGE
WRONG HEAD IS INSTALLED
AVOIDING DRY-UP TURN
POWER OFF
MOTOR ERROR TURN POWER
OFF
CANCELED FOR MOTOR
PROTECTION
Explanation
An unrecoverable error oc-
curred, or part replacement
that must be performed
by a service technician is
required.
The temperature of the lo-
cation where the machine
is installed has fallen below
the ambient temperature
at which the machine can
operate.
Output was stopped be-
cause a problem was found
in the data received.
A cartridge that cannot be
used was installed.
Unusable print heads are
installed.
The print heads were
forced to standby position
to prevent them from dry-
ing out.
A motor error occurred.
Either of the following
menu items is to be started
in a row:
• PUMP UP
• HEAD WASH
• INK RENEWAL
• POWERFUL CLEANING
• Filling with ink
Handling Messages and Error Messages
Action
Note the number displayed on the display screen, and then switch
off the sub power. After you switch off the power, inform your
authorized Roland DG Corp. dealer of the number that appeared
on the display screen.
Operation cannot be continued. Turn off the sub power. The
displayed temperature is the current ambient temperature of the
installation location. Bring the installed location to a temperature
at which operation is possible (20 to 32°C or 68 to 90°F) and allow
the machine to come to room temperature, and then turn on the
power.
Operation cannot be continued. Check whether or not there is an
error in the data. Check for a problem with the connector cable
or the computer, and redo the operation from the starting with
loading the media.
Remove the ink cartridge to clear the error. Use an ink cartridge of
the specified type.
Turn off the sub power. After turning the power off, contact the
your authorized Roland DG Corp. dealer.
Operation cannot be continued. Switch the sub power off, and
then back on. Opening the front cover while printing is in progress
causes an emergency stop. Never allow the print heads to remain
in this state.
Operation cannot be continued. Turn off the sub power. Next,
eliminate the cause of the error, then immediately switch on the
sub power. If the machine is allowed to stand with the error uncor-
rected, the print heads may dry out and become damaged. This
error may be caused by the media being set incorrectly.
Press any key other than the sub power switch to cancel the error
message.
When performing these menu items in a row, this error message
may display to prevent damage to the machine due to the over-
heating of pump motor.
In this case, allow the machine to stand for approximately 10
minutes before resuming operation.
Chapter 3 Appendix 67