Making Advanced Setup of Media
8.
Press [
] [
] [
pointer until it points to a position to the
inner left of the print area .
MEMO
For a test print, set "WIDTH" to 80 mm or
more, and "LENGTH" to 70 mm or more. An
error will occur and test prints cannot be
done if the area is smaller than this.
9.
Press [ENTER] .
10.
Close the front cover when it is open .
The print area is specified. Print heads return
to the standby position.
Make sure the "W (Width), L (Length), and H
(Height)" values on the menu screen are as
intended.
W:508mm L:330mm
H:100.0mm
MEMO
If you want to use the print area specified
here for next printing, switch "SET AT SETUP"
(p. 11) to "DISABLE. " With this setting, you
can make a setup of media without setting
the print area and base position.
14
Chapter 1 Fully Utilizing the Machine
] [
] to move the laser
Inner left of the
print area
Setting Print Area Using Center of
Media as Base Position
This is the print area setting method clear
specification of the print area is difficult, or
when the print site is curved or uneven.
MEMO
During print area setup, the procedure
can be performed with the front cover
open. However, if the front cover is left
open for more 40 seconds, the print heads
automatically return to the standby position.
The menu goes back to the previous menu
so you must repeat setup.
NOTE
Be sure to hold the handle of the front cover,
open and close it gently.
Procedure
1.
Set "SET AT SETUP" (p . 11) to "ENABLE . "
2.
Set "SET BASE POS . " (p . 12) to "CENTER . "
3.
Set up the media .
" "STEP 2: Installing Media and Setting
Height" (First Step Guide)
4.
When this screen appears, press any one of
[ ] [ ] [
] [
] .
SCAN:
000.0mm
FEED:
000.0mm
The flat table moves to the rear, the print
heads move to above the flat table, and the
laser pointer illuminates.