Ipv6 Neighbor - Planet Networking & Communication SGS-6340-24T4S Command Manual

Parameter:
parameter <seconds> is the time interval of sending Neighbor Solicitation Message, <seconds> value must be
between 1-3600 seconds, no command restores the default value 1 second.
Command Mode:
Interface Configuration Mode
Default:
The default Request Message time interval is 1 second.
Usage Guide:
The value to be set will include the situation in all routing announcement on the interface. Generally, very short time
interval is not recommended.
Example:
Set Vlan1 interface to send out Neighbor Solicitation Message time interval to be 8 seconds.
Switch(Config-if-Vlan1)#ipv6 nd ns-interval 8

23.2.15 ipv6 neighbor

Command:
ipv6 neighbor <ipv6-address> <hardware-address> interface <interface-type interface-name>
no ipv6 neighbor <ipv6-address>
Function:
Set static neighbor table entry.
Parameters:
Parameter ipv6-address is static neighbor IPv6 address,
hardware address, interface-type is Ethernet type, interface-name is Layer 2 interface name.
Command Mode:
Interface Configuration Mode
Default Situation:
There is not static neighbor table entry.
parameter hardware-address is static neighbor
23-14