Lldp Notification Interval; Lldp Toomanyneighbors - Planet Networking & Communication SGS-6340-24T4S Command Manual

8.9 lldp notification interval

Command:
lldp notification interval <seconds>
no lldp notification interval
Function:
When the time interval ends, the system is set to check whether the Remote Table has been changed. If it has, the
system will send Trap to the SNMP management end.
Parameters:
<seconds>is the time interval, ranging from 5 to 3600 seconds.
Default:
The time interval is 5 seconds.
Command Mode:
Global Mode.
Usage Guide:
After configuring the notification time interval, a "trap" message will be sent at the end of this time interval whenever
the Remote Table changes.
Example:
Set the time interval of sending Trap messages as 20 seconds.
Switch(config)#lldp notification interval 20

8.10 lldp tooManyNeighbors

Command:
lldp tooManyNeighbors {discard | delete}
Function:
Set which operation will be done when the Remote Table is full.
Parameters:
discard: discard the current message.
delete: Delete the message with the least TTL in the Remoter Table.
8-189