Port-Rate-Statistics Interval - Planet Networking & Communication SGS-6340-24T4S Command Manual

Parameters:
on: enables the auto-negotiation; off: disable the auto-negotiation.
Command mode:
Port configuration Mode.
Default:
Auto-negotiation is enabled by default.
Usage Guide:
This command applies to 1000Base-FX interface only. The negotiation command is not available for 1000Base-TX
or 100Base-TX interface. For combo port, this command applies to the 1000Base-FX port only but has no effect on
the 1000Base-TX port. To change the negotiation mode, speed and duplex mode of 1000Base-TX port, use
speed-duplex command instead.
Example:
Port 21 of Switch1 is connected to port 21 of Switch2, the following will disable the negotiation for both ports.
Switch1(config)#interface ethernet1/21
Switch1(Config-If-Ethernet1/21)#negotiation off
Switch2(config)#interface ethernet1/21
Switch2(Config-If-Ethernet1/21)#negotiation off

4.1.10 port-rate-statistics interval

Command:
port-rate-statistics interval <interval-value>
Function:
Set the interval of port-rate-statistics, ranging from 5 to 600.
Parameter:
interval-value: The interval of port-rate-statistics, unit is second, ranging from 5 to 600 with the configuration step of
5.
Default:
Only port-rate-statistics of 5 seconds and 5 minutes are displayed.
4-153