Lanier 5222 Operator's Manual page 74

Remote Maintenance by Telnet (mshell)
Access Type Configuration
You can select the access type from those listed below.
Protocol configuration
You should use the following command to set the protocols to active or inactive. If you set a
protocol to inactive, you cannot use all the registered numbers for it.
If you want to change the protocol settings for each registered number, use the following
command. Make sure that the protocol set to inactive using the above command, cannot set to be
active using this command.
Access Configuration
You can configure an address of a host depending on the protocols used. The Network Interface
Card accepts requests only from hosts having ad-dresses with access types of "read-only" or "read-
write". Enter "0" to have the Network Interface Card accept requests from any host without
requiring a specific type of access.
The following example shows how set the protocol for an address.
Note
6 - 14
msh> snmp number type access_type
msh> snmp {ip | ipx} {on | off}
•
"On" means active and "Off" means inactive
msh> snmp number active {ip | ipx} {on | off}
msh> snmp number {ip | ipx} address
•
When using the TCP/IP protocol, enter ip followed by a space and then the IP address.
•
When using the IPX/SPX protocol, enter ipx followed by a space and then the IPX
address followed by a decimal and then the MAC address of the Network Interface
Card.
Access Type Type of Access which is Permitted
read Read only access is permitted
write Read and write access is permitted
trap User is notified of trap message
no All access is denied
Additional Functions