Pre-Assembly Of The Paper Feed Motor - Epson TM-U675 Service Manual

Confidential

Pre-assembly of the Paper Feed Motor

Note:
Perform the following three steps only if your printer has a MICR unit.
1. Insert the paper feed motor into the motor shield case. Insert the paper feed motor gear into
the hole in the motor shield case. Check that the motor printed circuit board (PCB) fits into
the notch.
2. Insert two motor shield spacers into the motor shield case.
3. Attach the motor shield cover onto the motor shield case (two places). Align the screw holes
and the nibs on the opposite side, and push in so that they snap fit.
Screw (C.C.S-tite, 2.5X5)
Rev.D
781 Motor shield cover
725
739
Paper feed motor
Motor shield case
Figure 2-4
TM-U675/U675P (with autocutter) Service Manual
779
Motor shield spacer
780
726
Screw (C.B.S-tite F, 3X6)
Assembly and Disassembly 2-5