Epson TM-U675 Service Manual page 132

Confidential
6. Connect the power switch cable assembly to the main circuit board unit.
7. Connect the control panel cable to the main circuit board unit.
8. Pass the N. E. detector assembly unit lead wire through the hole in the plate and connect to
the main circuit board unit.
9. Pass the autocutter cable assembly through the hole in the plate and connect it to the main
circuit board unit.
2-98 Assembly and Disassembly
207
Control panel cable
209 Autocutter cable assembly
205 N.E. detector assembly lead wire
203 Power switch cable assembly
Figure 2-99
Rev.D