Error Messages - Yamaha R-N803 Owner's Manual

Optimizing the speaker settings automatically (YPAO)

Error messages

If any error message is displayed during the measurement, resolve the problem and perform YPAO again.
YPAO E-1
Noisy
Error message
E-1 Noisy
E-2 No Signal
E-3 No MIC
E-4 User Cancel
E-5 PHONES
E-10 Internal Error
E-20 No SPEAKERS
E-21 Control Knob
E-22 Pure Direct
Note
After checking the error message, press the cursor key (
– To start the measurement again:
B
Use the cursor keys (
– To exit YPAO:
B
Use the cursor keys (
44
En
The noise is too loud.
The YPAO microphone cannot detect test tones.
The YPAO microphone has been removed.
The measurement has been canceled.
The headphones are connected to the PHONES
jack of this unit.
An internal error has occurred.
Speakers are not detected.
The BASS/TREBLE/BALANCE/LOUDNESS
control positions are improper.
Pure Direct is turned on.
D
C
/ ) to select "Retry" and press ENTER. Proceed to Step 5 in page 43.
C
/ ) to select "Exit" and press ENTER.
Cause
) to return to the previous state and follow the procedure below,
Remedy
Keep the room quiet and start the measurement
again.
Connect the YPAO microphone to the YPAO
MIC jack firmly and start the measurement
again. If this error occurs repeatedly, contact the
nearest authorized Yamaha dealer or service
center.
Connect the YPAO microphone to the YPAO
MIC jack firmly and start the measurement
again.
Start the measurement again as necessary.
Disconnect the headphones and start the
measurement again.
Exit YPAO and then turn off and on this unit. If
this error occurs repeatedly, contact the nearest
authorized Yamaha dealer or service center.
Press SPEAKERS A/B to select the speakers to
be used and start the measurement again.
If this error occurs even when the speakers are
properly selected, turn off this unit and check
the speaker connections.
Set all the controls to the center position and
start the measurement again.
Press PURE DIRECT on the front panel to turn
off Pure Direct and start the measurement again.