Error Messages - Yamaha AVENTAGE RX-A3080 Owner's Manual

Error messages

If any error message is displayed during the measurement, resolve the problem and perform
YPAO again.
Error message
ERROR 1
Front speakers are not
detected.
ERROR 2
One of the surround speakers
cannot be detected.
ERROR 3
One of the front presence
speakers cannot be detected.
ERROR 4
One of the surround back
speakers cannot be detected.
ERROR 5
The noise is too loud.
ERROR 6
Surround back speakers are
connected, but no surround
speakers are connected.
ERROR 7
The YPAO microphone has
been removed.
ERROR 8
The YPAO microphone cannot
detect test tones.
ERROR 9
Canceled by user operation
ERROR 10
An internal error has occurred.
ERROR 11
One of the rear presence
speakers cannot be detected.
65
En
Remedy
Follow the on-screen instructions to exit YPAO, turn off the unit, and
then check the speaker connections.
Keep the room quiet and follow the on-screen instructions to start the
measurement again. If you select "Proceed", YPAO takes the
measurement again and ignores any noise detected.
Surround speakers need to be connected in order to use surround back
speakers. Follow the on-screen instructions to exit YPAO, turn off the
unit, and then reconnect the speakers.
Connect the YPAO microphone to the YPAO MIC jack firmly and follow
the on-screen instructions to start the measurement again.
Connect the YPAO microphone to the YPAO MIC jack firmly and follow
the on-screen instructions to start the measurement again. If this error
occurs repeatedly, contact the nearest authorized Yamaha dealer or
service center.
Follow the on-screen instructions to start the measurement again. To
cancel the measurement, select "Quit".
Follow the on-screen instructions to exit YPAO, turn off and on the unit.
If this error occurs repeatedly, contact the nearest authorized Yamaha
dealer or service center.
Follow the on-screen instructions to exit YPAO, turn off the unit, and
then check the speaker connections.