Error Messages - Yamaha RXA670 Owner's Manual

Error messages

If any error message is displayed during the measurement, resolve the problem and
perform YPAO again.
Error message
TV screen
LINK MASTER STEREO TUNED ZONE
SLEEP PARTY 2 A
OUT 2 Hi -R es ENHANCER YPAO VOL. A- DRC
ECO
E-5:NOISY E-5:NOISY
Front display
n
Procedure to handle errors
1
Check the content of error message and press ENTER.
2
Use the cursor keys (e/r) to select the desired operation.
To exit the YPAO measurement:
1
Select "EXIT" and press ENTER.
2
Use the cursor keys (q/w) to select "Exit" and press ENTER.
3
Disconnect the YPAO microphone from the unit.
To retry the YPAO measurement from beginning:
1
Select "RETRY" and press ENTER.
To proceed with the current YPAO measurement (for E-5 and E-9
only):
1
Select "PROCEED" and press ENTER.
3 B
VOL. MUTE VIRTUAL
FPL FPR
SL SW SR
SBL SB SBR
Error message Cause
E-1:No Front SP
Front speakers are not
(E-1:NO FRNT SP) detected.
One of the surround
E-2:No Sur. SP
speakers cannot be
(E-2:NO SUR SP)
detected.
One of the presence
E-3:No F.PRNS SP
speakers cannot be
(E-3:NO FPR SP)
detected.
A surround back speaker is
E-4:SBR → SBL
connected to the R side
(E-4:SBR → SBL)
only.
E-5:Noisy
The noise is too loud.
(E-5:NOISY)
Surround back speakers are
E-6:Check Sur.
connected, but no surround
(E-6:CHECK SUR)
speakers are connected.
E-7:No MIC
The YPAO microphone has
(E-7:NO MIC) been removed.
E-8:No Signal
The YPAO microphone
(E-8:NO SIGNAL) cannot detect test tones.
E-9:User Cancel
The measurement has been
(E-9:CANCEL) canceled.
E-10:Internal Err.
An internal error has
(E-10:INTERNAL) occurred.
Note
Texts in parentheses denote indicators on the front display.
37
En
Remedy
Exit YPAO, turn off the unit, and then
check the speaker connections.
When using only one surround back
speaker, you need to connect it to the
SINGLE jack (L side). Exit YPAO, turn off
the unit, and then reconnect the speaker.
Keep the room quiet and retry YPAO. If
you select "PROCEED", YPAO takes the
measurement again and ignores any
noise detected.
Surround speakers need to be
connected in order to use surround back
speakers. Exit YPAO, turn off the unit,
and then reconnect the speakers.
Connect the YPAO microphone to the
YPAO MIC jack firmly and retry YPAO.
Connect the YPAO microphone to the
YPAO MIC jack firmly and retry YPAO. If
this error occurs repeatedly, contact the
nearest authorized Yamaha dealer or
service center.
Retry or exit YPAO as necessary.
Exit YPAO, and turn off and on the unit. If
this error occurs repeatedly, contact the
nearest authorized Yamaha dealer or
service center.