Error Messages From Ypao - Yamaha RX-V385 Owner's Manual

Error messages from YPAO

If any error message is displayed during the measurement, resolve the problem and
perform YPAO again.
Error message
TV screen
LINK MASTER STEREO TUNED ZONE
2 A
SLEEP PARTY
OUT 2
Hi -R es ENHANCER YPAO VOL. A- DRC
ECO
E-5:NOISY E-9:CANCEL
Front display
3 B
VOL. MUTE VIRTUAL
FPL FPR
SL SW SR
SBL SB SBR
Error message Cause
E-1:No Front SP
Front speakers are not
detected.
(E-1:NO FRNT SP)
One of the surround
E-2:No Sur. SP
speakers cannot be
(E-2:NO SUR SP)
detected.
E-5:Noisy
The noise is too loud.
(E-5:NOISY)
E-7:No MIC
The YPAO microphone has
been removed.
(E-7:NO MIC)
E-8:No Signal
The YPAO microphone
cannot detect test tones.
(E-8:NO SIGNAL)
E-9:User Cancel
The measurement has been
canceled.
(E-9:CANCEL)
E-10:Internal Err.
An internal error has
occurred.
(E-10:INTERNAL)
Note
▪ Text in parentheses denotes indicators on the front display.
▪ To exit the YPAO measurement for resolving the problem, use the cursor keys to select "EXIT" and press
ENTER.
▪ For the error messages E-5 and E-9 only, you can proceed with the current YPAO measurement. Press
ENTER, and then use the cursor keys to select "PROCEED" and press ENTER.
▪ To retry the YPAO measurement from beginning, press ENTER, and then use the cursor keys to select
"RETRY" and press ENTER.
29
En
Remedy
Exit YPAO, turn off the unit, and then
check the speaker connections.
Keep the room quiet and retry YPAO. If
you select "PROCEED", YPAO takes the
measurement again and ignores any
noise detected.
Connect the YPAO microphone to the
YPAO MIC jack firmly and retry YPAO.
Connect the YPAO microphone to the
YPAO MIC jack firmly and retry YPAO. If
this error occurs repeatedly, contact the
nearest authorized Yamaha dealer or
service center.
Retry or exit YPAO as necessary.
Exit YPAO, and turn off and on the unit. If
this error occurs repeatedly, contact the
nearest authorized Yamaha dealer or
service center.