Fan - HP Spectre 13-v0 SERIES Maintenance And Service Manual

Table of Contents

Advertisement

Fan

Description
Fans (includes left and right fans)
Before removing the fans, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
5.
Remove the battery (see
Remove the fans:
1.
To remove the left fan, disconnect the fan cables from the system board (1), remove the two Phillips
PM2.0×3.0 screws (2), and then lift the fan at an angle (approximately 45 degrees) and pull it out from
under the edge of the computer (3).
NOTE:
Bottom cover on page
Battery on page
You may need to route the left fan cable under the WLAN antenna cables.
24).
26).
Component replacement procedures
Spare part number
855629-001
33

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Spectre pro13 g1

Table of Contents