Loading Paper Into Tray 2 - Ricoh pro c901 Troubleshooting Manual

• To use the A3/11" × 17" tray unit, you must replace Tray 1.
• Make sure the paper stack is flush to the right side fence.
• The tray can hold up to 1,000 sheets of paper. Do not stack paper over the limit mark.
1. Carefully pull out the paper tray until it stops.
2. Place the paper print side down along the edge on the left.
3. Carefully slide the paper tray fully in.

Loading Paper into Tray 2

This section describes how to load paper in Tray 2.
• Various sizes of paper can be loaded in Tray 2 by adjusting the positions of side fences and end
fence.
• If the paper tray is pushed vigorously when putting it back into place, the position of the side fences
may slip out of place.
• Check the paper edges are aligned with the right side.
• The tray can hold up to 550 sheets. Do not stack paper over the limit mark.
CAL042
CAL043
Loading Paper
2
41