Ricoh PE-P4 Field Service Manual page 139

Training Retries
Protocol Definition
Encoding
T0 Timer
Protocol Definition
Timer
T1 Timer
T4 Timer
Silence Detection
CNG Tone
Detection Time
RX Settings
CNG Cycles
Tone Sound
Monitoring
This sets the number of training retries to be repeated
before automatic fallback.
[1 Time/ 2 Times (Default)/ 3 Times/ 4 Times]
Sets the compression method for Tx/Rx.
[MMR+MR+MH (Default)/ MR+MH/ MH]
Timeout for response from the called station in automatic
sending mode
[35 Sec/ 45 Sec/ 55 Sec/ 60 Sec(Default)/ 90 Sec/
140 Sec]
Set the time length for the T1 timer.
[40 Sec (Default)/ 50 Sec]
Set the time length for the T4 timer.
[3 Sec (Default/ 4.5 Sec]
Silence (No tone) detection time (Rx mode : FAX/ TAD
Only)
After the line is connected via the external telephone, the
machine can detect silence (no tone) for the time length
specified by this setting.
[30 sec (Default)]
CNG tone detection time ( RX mode : FAX / TEL, FAX /
TAD Only)
After the line is connected via the external telephone, the
machine can detect a CNG signal for the time length
specified by this setting.
[5 Sec (Default)/ 10 Sec]
Number of CNG cycles to be detected
This setting is only effective for FAX/TAD mode.
[1.5 Cycle (Default)/ 2.0 Cycle]
Determines the period when tones from the line are
monitored.
[No Monitoring/ Up To Phase B (Default)/ All TX
Phases]
Service Menu
137