Cisco Aironet 1520 Series Mounting Instructions page 53

Loosen the round end of the liquid tight adapter by turning counterclockwise, but do not remove (see
Step 4
Figure
Figure 34
1 Thread end
Note
Insert a bare end of the DC power cable into the rounded end of the liquid tight adapter (see
Step 5
and pull approximately 6 inches of cable through the adapter.
Strip the DC cable jacket back about 1 inch to expose the wires and strip the insulation about 3/8 in. (9.5
Step 6
mm) from each wire.
78-18269-04
34).
Liquid Tight Adapter
The liquid tight adapter accepts a cable diameter of 0.20 to 0.35 in. (0.51 to 0.89 cm).
Cisco Aironet 1520 Series Outdoor Mesh Access Point Mounting Instructions
2 Round end
Powering the Access Point
Figure 34),
53