Warnings - Cisco Aironet 1520 Series Mounting Instructions

Warnings

Cable Strand Installation
To install the access point on a cable strand, you need the following additional parts:
•
•
•
Hazardous Location Installations
To install the access point in a hazardous location, you need the following additional parts:
•
•
•
•
•
•
•
•
See the
and procedures.
Warnings
Translated versions of all safety warnings are available in the safety warning document that shipped with
your access point.
See
hazardous location installations.
Cisco Aironet 1520 Series Outdoor Mesh Access Point Mounting Instructions
4
Cable strand mount kit (AIR-ACCSMK1520=)
Strand mounting bracket
–
Strand clamp bracket
–
Four cable clamps
–
Four M8 flange nuts
–
Four hex bolts (M8 x16)
–
Four M8 split lock washers and six M8 flat washers
–
Customer supplied 13-mm box-end wrench or socket set
Customer supplied adjustable wrench, 22 mm socket, or Sealcon S-2200-WR socket wrench
Two Cisco supplied PG-13 1/2 NPT conduit adapters
One Cisco supplied grounding lug with screw and lock washers
Customer supplied 13-mm box-end or socket set
Customer supplied adjustable wrench, 22 mm socket, or Sealcon S-2200-WR socket wrench
Customer-supplied #1 Phillips or standard screwdriver
Customer supplied appropriate lengths of 1/2 NPT rigid metal conduit
Customer supplied wire strippers
Customer supplied ground lug crimping tool (Panduit CT-720 with CD-720-1 die)
"Installing the Access Point in Hazardous Locations" section on page 57
"Installing the Access Point in Hazardous Locations" section on page 57
for detailed information
for warnings that apply to
78-18269-04