Unpacking The Access Point; Tools And Materials That You Supply - Cisco Aironet 1520 Series Mounting Instructions

Unpacking the Access Point

Unpacking the Access Point
If you are mounting the access point in a hazardous location, refer to the
Note
Hazardous Locations" section on page
must follow.
When you are unpacking the access point, do not remove the foam blocks attached to the antenna
connectors. The foam protects the antenna connectors during installation.
Follow these steps to unpack the access point:
Open the shipping container and carefully remove the contents.
Step 1
Return all packing materials to the shipping container, and save it.
Step 2
Ensure that all items listed in the
Step 3
damaged or missing, notify your authorized Cisco sales representative.
Package Contents
Each access point package contains the following items:
•
•
•
•
•
•
Note

Tools and Materials that You Supply

•
•
•
•
•
•
Cisco Aironet 1520 Series Outdoor Mesh Access Point Mounting Instructions
2
Access point
Cisco product documentation and translated safety warnings
Grounding lug with two screws and lock washers
Three liquid tight adapters
Two-pin DC power connector
Ground lug (Panduit PLCD6-10A-L) and screws with lock washers
The hazardous location version of the access point is a specially modified orderable unit that
ships with two PG-13 1/2 NPT conduit adapters and a grounding lug with screw and lock
washers.
Ground lug crimping tool (Panduit CT-720 with CD-720-1 die)
6-AWG copper ground wire
13 mm box-end wrench or socket set
Adjustable wrench, 22 mm socket, or Sealcon S-2200-WR socket wrench
Small flat screwdriver for DC power connector
Optional power injector (AIR-PWRINJ1500-2=)
57, which contains additional requirements and procedures you
Package Contents section are included in the shipment. If any item is
"Installing the Access Point in
78-18269-04