Using The Reset Button - Cisco Aironet 1520 Series Mounting Instructions

Mounting the Access Point

Using the Reset Button

The access point has a reset button located on the bottom of the unit (see
recessed in a small hole that is sealed with a screw and a rubber gasket. The reset button can be used to
perform these functions:
•
•
Figure 25
1
Reboot the Access Point
To reboot (power cycle) the access point, follow these steps:
Use a Phillips screwdriver to remove the reset button screw. Be careful not to loose the screw.
Step 1
Use a straighten paperclip, and push the reset button for less than 10 seconds. This causes the access
Step 2
point to reboot (power cycle), all LEDs turn off for approximately 5 seconds and then the LEDs
reactivate.
Replace the reset button screw, and use a Phillips screwdriver to tighten to 22 to 24 in. lbs
Step 3
(2.49 to 2.71 Nm).
Cisco Aironet 1520 Series Outdoor Mesh Access Point Mounting Instructions
38
Reset the access point—press the reset button for less than 10 seconds.
Disable battery backup power—press the reset button for more than 10 seconds.
Reset Button Location
Reset button location
Figure 25). The reset button is
78-18269-04