Cisco Aironet 1520 Series Mounting Instructions page 27

Screw a M8 x16 bolt (without a flat or lock washer) in the top support bolt hole on each side the access
Step 11
point (see
(0.635 cm).
Figure 14
1 Ground lug screw holes location
2 M8 x16 bolt (without flat or lock washers)
(supplied with pole mount kit)
Position the two bolts on the access point into the access point quick-mount notch on the mounting
Step 12
bracket (see
Note
78-18269-04
Figure 14). Do not screw the bolt all the way in. Leave a gap of approximately 0.25 in
Location of Access Point Top Support Bolt Hole
Figure 15).
The access point should be positioned with the LEDs on the bottom to allow viewing from the
ground and with the hinged cover facing out.
Cisco Aironet 1520 Series Outdoor Mesh Access Point Mounting Instructions
3 Second bolt hole location
Mounting the Access Point
27