Cisco Aironet 1520 Series Mounting Instructions page 48

Powering the Access Point
If your access point contains a backup battery pack, you must press the reset button for 10 seconds or
more (see the
Step 3 When using the streetlight power tap adapter (AIR-PWR-ST-LT-R3P=), ensure that the access point is
mounted within 3 ft (1 m) of the outdoor light control. For mounting instructions, refer to the
the Access Point on a Pole" section on page
Ensure a 6-AWG ground wire is attached to the access point (see
Step 4
streetlight pole (for instructions see
Figure 31
1
1 Outdoor light control
2
Streetlight power tap adapter
Refer to
Step 5
placed between the outdoor light control and its fixture. The LC-10 twist-lock adapter is designed to be
used with LC-10 listed outdoor light controls operating at 100 to 480 VAC, 50 to 60 Hz.
Step 6 Disconnect the outdoor light control from its fixture.
Verify that the voltage available at the fixture is between 100 and 480 VAC, 50 to 60 Hz.
Step 7
Turn off power to the fixture at the designated circuits.
Step 8
Caution When installing the streetlight power tap adapter to the access point AC power connector, always
connect the access point end of the cable FIRST. When removing the streetlight power tap adapter,
always disconnect the access point end of the cable last.
Note
Cisco Aironet 1520 Series Outdoor Mesh Access Point Mounting Instructions
48
"Disabling Backup Battery Power" section on page
Using the Streetlight Power Tap Adapter
2
Figure 31. The streetlight power tap adapter uses a 3-pronged LC-10 twist-lock adapter that is
Ensure that your antennas are connected to the access point before you apply power to the access
point.
21.
Grounding the Access Point, page
3
3 6-AWG copper grounding wire
39.)
Figure 31) and connected to the
39).
"Mounting
78-18269-04