Fujitsu PRIMERGY RX100 S6 Options Manual page 65

Ê Insert the prepared server into the protruding interior telescope rails (2) until
the rails engage.
Ê Release the locking mechanism (a or b) of both rails (3).
Ê Push the server as far as it will go into the rack (4).
Ê Fasten the server to the rack (5) using the two knurled screws (front panel).
Ê Reconnect all the cables you disconnected beforehand on the rear of the
server.
Ê Connect all power plugs to the power outlets.
Ê Press the on/off key to start up the server.
RX100 S6
Options Guide
Closing the server
65