Fujitsu PRIMERGY RX100 S6 Options Manual page 56

Front VGA module
Figure 39: Sliding in the Front VGA module
Ê Push the Front VGA module into the bay from the front (1).
Ê Thread the cable through the openings (2).
Figure 40: Connecting the Front VGA cable to the system board
Ê Connect the Front VGA cable to the system board (see the cabling plans in
the Appendix).
Ê Route the cable in the two cable clamps.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page
56
63.
Options Guide
RX100 S6