Fujitsu PRIMERGY RX100 S6 Options Manual page 45

A
Figure 25: Installing the riser module 1
Ê Insert the riser card into the system board slot (1).
Make sure that the two guiding bolts (A) at the right side of the riser holder
engage correctly.
Ê Push the green lock bars of the riser module 1 in direction of the arrows (2).
Ê If necessary, connect the cables to the expansion card and the other
components.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page
RX100 S6
Installing an expansion card
63.
Options Guide 45