Fujitsu PRIMERGY RX100 S6 Options Manual page 53

Figure 36: Connecting BBU cable to controller
Ê Install a controller as described in the
on page 40.
Ê Connect the BBU cable to the controller.
V
CAUTION!
Make sure that the connector side with two pin rows is on the top.
Otherwise you risk short-circuits.
Figure 37: Routing BBU cable
Ê Route the BBU cable as shown in the figure.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page
RX100 S6
section "Installing an expansion card"
63.
Options Guide
Installing a BBU
53