Switch - Cisco IE 4000 Hardware Installation Manual

Running Express Setup
6. Power on or reset the IE4000:
Use LEDs to monitor boot progress:
— Sys blinking: bootloader
— Sysl Blank: POST
— Sys solid: exit post, IOS initializing
— Sys and alarm LEDs green: IOS init done
— ~90 – 100 seconds after power on
— EXP blinking: ready for express setup process
7. Insert paper clip into express setup button for 1-2 seconds.
When released, port Gig1/1 LED starts flashing green.
8. Connect computer to port Gig1/1.
LED continues to blink.
9. After computer has IP Address (169.254.0.2), point browser to http://169.254.0.1.
10. Leave the username blank and enter the default password, cisco.
Note The switch ignores text in the username field. The Express Setup window appears.
Troubleshooting: If the Express Setup window does not appear, make sure that any pop-up blockers or proxy
settings on your browser are disabled and that any wireless client is disabled on your computer.
11. Enter all entries in English letters and Arabic numbers.
42